Integrates UniPi with nymea
Categories: diy
Technologies: network, serial-port, modbus
UniPi#
UniPi#
Supports UniPi 1.1, UniPi Lite and all Neuron models as well as the Neuron extensions.
This plug-in does not make use of Evok, it communicates directly with the Modbus TCP layer, or over Modbus RTU with the Neuron extensions. To add one-wire devices, use the nymea onewire plug-in.
Supported Things#
UniPi 1.1
UniPi 1.1 light
Neuron
all models
Neuron Extensions
all models
- General Features:
No internet connection required
Switch digital outputs
Read digital inputs
Switch user led
Set analog outputs
Read analog inputs
Requirements#
UniPi 1.1 & UniPi 1.1 light
Neuron
Neuron TCP modbus server must be installed.
Neuron Extensions
Set the DIP settings accordind to the plug-in settings
General requirements:
The package “nymea-plugin-unipi2” must be installed
For one-wire sensors the package “nymea-plugin-onewire” must be installed.
Device setup for Neuron devices#
The nymea unipi plug-in requires the Neuron UniPi Kernel for Neuron devices, this is not required for Neuron Extensions or UniPi 1.1. To install the kernel module follow the instuctions in the UniPi knowledge base.
https://kb.unipi.technology/en:sw:04-unipi-firmware
Before you can add IOs you need to setup the UniPi Gateway device inside nymea, after that nymea recognises the available IOs.