Send and receive raw UDP commands.
Categories: tool
Technologies: network
UDP Commander#
UDP commander#
This plugin allows to receive UDP packages over a certain UDP port and generates an event if the message content matches the param command.
Note
Note: This plugin is ment to be combined with a rule.
Usage#
If you create an UDP Commander on port 2323 and with the command "Light 1 ON", following command will trigger an event in nymea and allows you to connect this event with a rule.
Note
Note: In this example nymea is running on localhost
$ echo "Light 1 ON" | nc -u localhost 2323
OK
This allows you to execute actions in your nymea system when a certain UDP message will be sent to nymea.
If the command will be recognized from nymea, the sender will receive as answere a "OK" string.
Supported Things#
UDP Commander
* Send UDP strings
* Set target IP-address and port
UDP Received
* Received UDP strings
* Set receiveing port
Requirements#
The package “nymea-plugin-udpcommander” must be installed
The selected port must be available on the host system.