Navigation

    Amperfied - Heidelberg

    Connects nymea to a Amperfied/Heidelberg wallboxes. Currently supported models are:

    • Amperfied Energy Control
    • Amperfied connect.home
    • Amperfied connect.solar
    • Amperfied connect.business

    Requirements

    nymea requires the use of a firmware greator or equal version 1.0.7 on the wallbox.

    Amperfied Energy Control

    The Amperfied Energy Control is a Modbus RTU device. This means it must be connected to the nymea system using an RS485 port. The Modbus RTU must be configured with a baud rate of 19200, even parity, 8 data bits and 1 stop bit. In order to allow nymea to automatically discover the wallbox on the bus, the Modbus slave ID must be in the range of 1 - 20. If a higher slave ID number is required, the manual setup is to be used.

    Amperfied connect.home/solar/business

    The Amperfied connect.home is a Modbus TCP device. This means it must be connected to the same network the nymea system is in.

    Filter

      We care about your privacy.

      We use cookies to offer a better browsing experience and analyze site traffic. Please review our privacy policy & cookies information page. By clicking accept, you consent to our privacy policy & use of cookies.